DDR Checker

EXPO and XMP: why new RAM often runs slower than advertised

Updated 2026-10-30

A new DDR5-6000 kit usually does not run at 6000 MT/s once installed, but at 4800 or 5600 MT/s. That is not a fault: without further settings every module starts at a safe default speed defined by JEDEC, the standards body for memory. The advertised speed only comes with a memory profile.

What the profiles are

Every module carries a small memory chip (SPD) in which the maker stores its settings. Besides the JEDEC values, faster kits hold one or more profiles with a higher speed, tighter timings and often a slightly higher voltage:

Many kits have both. Motherboards for AMD processors can usually apply XMP too, under a name of the board maker's own (DOCP at ASUS, for example). The values of an EXPO profile, though, are meant for and tested on AMD systems.

How to turn the profile on

What the profile does not guarantee

A profile is a factory overclock. The module maker has tested the kit at these values, but whether they run stably in your system also depends on the memory controller in the processor and on the motherboard. Formally a profile runs outside the specification of the processor and the memory, and the makers point this out in their warranty terms.

What it means when buying

More guides